![]() ![]() ![]() Switch on ignition (dont start engine) and in the DP0 section of CLIP, select on the left hand side the monitor icon, select the "pressure regulation group" - specify 9999 in the time block left lower corner and click start monitoring. Switch off ignition and let the car sit for about 5 minutes. Hopefully you changed the ATF so then you need to zero the wear counter and also add the date you changed it - if you didn't change the ATF its going to depend a lot on luck because the oil properties are unknown You need to use "reprogram" and install the latest firmware for the particular DP0 - DO OBSERVE THE BATTERY CHARGER WARNING ISSUED AS PREREQUISITE FOR THE PROCESS ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |